Day 12 House Assembly

Sunday, 1/14/18

We took the day off. It's been nearly two weeks of solid work, often in very cold conditions. It was time for a day of rest.

Comments

Post a Comment

Popular posts from this blog

Crane Talk

Image
BWC rented a hydraulic truck crane for the house assembly from WO Grubb . They specified a 50 ton crane, but Grubb didn't have one available. Instead, they sent an 80 ton crane. It has five stabilizing pads, including one that's under the front of the truck. The counterweight consists of four big pieces of steel that weight 4000 or 6000 lb each. The crane looked very well maintained. We had two operators over the course of the 14 days of the crane operation, Mike and Charlie. They both were excellent. 80 Ton Crane The picture may not convey the size of the vehicle. On the side of the crane is a dimension chart. We had already used the crane dimensions to locate where the center pin would go, allowing for clearance of the counterweight to swing 360 degrees. This label also has lifting and counterweight information. Crane Dimensions I had done crane work in the past, but never with a boom crane, so there were some new hand signals to learn. For example, "Boom down,...
Read more

Wood Stove, Framing, and Rough-in

Image
Things have been busy, with interior framing, rough-ins, and the wood stove installation. The last post showed creating the wood stove hearth. The masons have been here and finished the wall behind the wood stove. I moved the stove into place and cut the connector pipe for the fresh air intake. Bay Stoves supplied the stove pipe and did the install. I preferred that they climb up on the roof and work on the scaffolding to install the flue. Installing the exterior stove pipe Jotul 400 Wood Stove and Flue We did a good job of aligning the hearth, the wall, and the wood stove. Everything went together as it should. The flue goes straight up through the roof. It is about 25ft of flue, mostly double wall flue pipe. Only the first four foot section is single-wall stove pipe. The fresh air intake works great, preventing warm inside air from feeding the fire. It will also prevent the cool inside air from leaving the house in the summer. We have a big pile of scrap lumber and the woo...
Read more

Basement and garage slabs get poured

Image
The basement and garage slabs were poured yesterday. Four truckloads of concrete were delivered for the job. The basement has two layers of 2 inch Owens Corning Foamular 250 rigid insulation, with Steggo moisture barrier (the yellow sheet) between the layers. It is fall and a lot of leaves fell into the basement over the weekend. I used a leaf blower/vacuum to suck up most of the leaves Sunday afternoon before the Monday pour. The copper sheathing along the top of the foundation is there as part of the jig to make sure the steel beam down the center is the proper height. Ready for the pour They used a laser transit to determine the height of the concrete slab and get it level. They would level a spot every 6 ft or so and then use a long board or a vibrating metal strip to smooth and level the concrete between the measured spots. Pouring the basement slab The concrete pump truck is a pretty interesting piece of equipment. I'm sure it is expensive. But it certainly beats usi...
Read more